Long-term stop of the vehicle, because of the erosion of the atmosphere caused by the assembly and the technical situation of the organization gradually deteriorated, resulting in the loss Sensor of the original technical performance. In order to mitigate this adverse effect, the owner should always carry out the necessary maintenance work on the parked vehicle so that it is in good condition.

    Special reason, the owner of his car idle for some time. However, car idlers can not be idle. Long-term stop of the vehicle, because of the erosion of the atmosphere caused by the assembly and the technical situation of the organization gradually deteriorated, resulting in the loss of the original technical performance. In order to mitigate this adverse effect, the owner should always carry out the necessary maintenance work on the parked vehicle so that it is in good condition. Car corrosion is mainly caused by the combination of moisture, oxygen and corrosive substances in the air. Therefore, for long-term parking of the car, should keep the metal surface clean. The parking garage should be kept Suction Control Valve in the garage, so that the relative humidity of the air is kept below 70%. Need to promptly remove the car on the dust, dirt and moisture. In the easy parts of the corrosion and mechanical surface should be coated with oil, grease or oil paper bandaged up. For the holes in the assembly mechanism, should be sealed to avoid air, moisture and dust into the interior.

    Rubber products on the car, such as tires, belts and dust cover, often occur aging, expansion or shape of the phenomenon, resulting in deterioration of performance, shorter service life. Aging products, mainly due to rubber is not saturated polymer hydrocarbons, easy to absorb oxygen in the air and oxidation, while vulcanized rubber also has a certain permeability, oxygen easily into the internal oxidation. Especially direct sunlight, can promote the rapid aging of rubber. Rubber products are gasoline, oil pollution, will lead to volume expansion, gelatin loose, elastic decline. In order Speed Sensor to prevent the aging of rubber products, should avoid direct sunlight and mineral oil contact.

   Carpets and other linen products are easy to absorb moisture. Especially in wet areas and rainy season, more susceptible to mildew. So the owner should be on the car's cotton and linen products often check, timely drying, keep dry. The anti-blast performance of gasoline is determined by the octane number of gasoline. When the car is stopped for a long time, the octane number of the gasoline decreases with the loss of the light component and the increase in the colloidal content, thereby reducing its antiknock. Therefore, the gasoline tank should be tightly closed, and to avoid the temperature is too high. Gas storage time is best not too long.

  Often check the working conditions of the engine, idle operation 4-5min, check the operation of the engine. If there are abnormal phenomena, need to timely adjustment, maintenance. Also check the battery regularly. Battery electrolyte liquid surface must Throttle Position Sensor be higher than the plate 10-15mm, insufficient to add distilled water in time, should keep the battery is sufficient, if necessary, the battery should be charged.